Formatting changes on README.md v7

README.md

@@ -29,22 +29,22 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
     sudo apt-get upgrade
     sudo pip3 install --upgrade setuptools
     ```
-	* If this fails, try this and repeat step 1
+        * If this fails, try this and repeat step 1
-	    ```
+            ```
             sudo apt-get install python3-pip
 	    ```
-	* Recommended, but may not be required, setting your Python install to default with Python 3. There are multiple ways to do this, here's an example:
+        * Recommended, but may not be required, setting your Python install to default with Python 3. There are multiple ways to do this, here's an example:
-		```
+            ```
-		sudo apt-get install -y python3 git python3-pip
+            sudo apt-get install -y python3 git python3-pip
-		sudo update-alternatives --install /usr/bin/python python $(which python2) 1
+            sudo update-alternatives --install /usr/bin/python python $(which python2) 1
-		sudo update-alternatives --install /usr/bin/python python $(which python3) 2
+            sudo update-alternatives --install /usr/bin/python python $(which python3) 2
-		sudo update-alternatives --config python
+            sudo update-alternatives --config python
-		```
+            ```
 2. Enabling I2C and SPI, which is only required to be done **once** for **each** Raspberry Pi:\
     **Only Required if you are using multiple devices on your Raspberry Pi, if not, move to step 3**\
-    **Important:**
+    **Important:**\
-        > If you are using a GPIO wiring setup for the LEDs that does not support I2C, you will not see anything show up for the LEDS.\
+    > If you are using a GPIO wiring setup for the LEDs that does not support I2C, you will not see anything show up for the LEDS.\
-	> Again, this is only for if you have **OTHER** devices you plan on hooking up to make sure they still show up under I2C\
+    > Again, this is only for if you have **OTHER** devices you plan on hooking up to make sure they still show up under I2C\
     * Enabling I2C:
 	* From Command Line:
 		```