Formatting changes on README.md v9

README.md

@@ -30,28 +30,29 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
     sudo pip3 install --upgrade setuptools
     ```
     * If this fails, try this and repeat step 1
-    ```
-    sudo apt-get install python3-pip
-    ```
-        * Recommended, but may not be required, setting your Python install to default with Python 3. There are multiple ways to do this, here's an example:
-            ```
-            sudo apt-get install -y python3 git python3-pip
-            sudo update-alternatives --install /usr/bin/python python $(which python2) 1
-            sudo update-alternatives --install /usr/bin/python python $(which python3) 2
-            sudo update-alternatives --config python
-            ```
+        ```
+        sudo apt-get install python3-pip
+        ```
+    * Recommended, but may not be required, setting your Python install to default with Python 3.\ 
+    There are multiple ways to do this, here's an example:
+        ```
+        sudo apt-get install -y python3 git python3-pip
+        sudo update-alternatives --install /usr/bin/python python $(which python2) 1
+        sudo update-alternatives --install /usr/bin/python python $(which python3) 2
+        sudo update-alternatives --config python
+        ```
 2. Enabling I2C and SPI, which is only required to be done **once** for **each** Raspberry Pi:\
     **Only Required if you are using multiple devices on your Raspberry Pi, if not, move to step 3**\
-    **Important:**\
+    **Important:**
     > If you are using a GPIO wiring setup for the LEDs that does not support I2C, you will not see anything show up for the LEDS.\
-    > Again, this is only for if you have **OTHER** devices you plan on hooking up to make sure they still show up under I2C\
+    > Again, this is only for if you have **OTHER** devices you plan on hooking up to make sure they still show up under I2C
     * Enabling I2C:
 	* From Command Line:
-		```
-		sudo apt-get install -y python-smbus
-		sudo apt-get install -y i2c-tools
-		sudo raspi-config
-		```
+	    ```
+	    sudo apt-get install -y python-smbus
+	    sudo apt-get install -y i2c-tools
+	    sudo raspi-config
+	    ```
 	* Interfacing Options > I2C > Enable > Yes
 	    > If you did not hit "finish" you can repeat these steps but change out the I2C for the SPI
     * Enabling SPI: