Formatting changes on README.md v2

README.md

@@ -33,7 +33,6 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
 	    ```
 	    sudo apt-get install python3-pip
 	    ```
-	
 	* Recommended, but may not be required, setting your Python install to default with Python 3. There are multiple ways to do this, here's an example:
 		```
 		sudo apt-get install -y python3 git python3-pip
@@ -46,7 +45,6 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
 	**Important:**
 	> If you are using a GPIO wiring setup for the LEDs that does not support I2C, you will not see anything show up for the LEDS.\
 		Again, this is only for if you have **OTHER** devices you plan on hooking up to make sure they still show up under I2C\
-    
     * Enabling I2C:
 		* From Command Line:
 			```
@@ -56,7 +54,6 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
 			```
 		* Interfacing Options > I2C > Enable > Yes
 			> If you did not hit "finish" you can repeat these steps but change out the I2C for the SPI
-			
 	* Enabling SPI:
 		* From Command Line: 
 			```
@@ -69,7 +66,6 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
 		    ```
 		    sudo reboot
 		    ```
-		
 	* Testing I2C and SPI after reboot:
 		* I2C Testing:
 			```
@@ -86,7 +82,6 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
 			ls -l /dev/spidev*
 			```
 			> This should return a device for each SPI bus (two)
-			
 3. Installing Python Support Libraries:
 	* GPIO - If not already installed:
 		```
@@ -120,8 +115,6 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
 		```
 		sudo reboot
 		```
-		
-		
 ## Usage
 
 TBD