Formatting changes on README.md v12

README.md

@@ -47,14 +47,14 @@ tickerPi is a Python Program to handle WS281X  LED interactions on a Raspberry P
     > If you are using a GPIO wiring setup for the LEDs that does not support I2C, you will not see anything show up for the LEDS.\
     > Again, this is only for if you have **OTHER** devices you plan on hooking up to make sure they still show up under I2C
     * Enabling I2C:
-	* From Command Line:
+        * From Command Line:
-	    ```
+            ```
-	    sudo apt-get install -y python-smbus
+            sudo apt-get install -y python-smbus
-	    sudo apt-get install -y i2c-tools
+            sudo apt-get install -y i2c-tools
-	    sudo raspi-config
+            sudo raspi-config
-	    ```
+            ```
-        * Interfacing Options > I2C > Enable > Yes
+                * Interfacing Options > I2C > Enable > Yes
-            > If you did not hit "finish" you can repeat these steps but change out the I2C for the SPI
+                    > If you did not hit "finish" you can repeat these steps but change out the I2C for the SPI
     * Enabling SPI:
         * From Command Line:
             ```